• Exterior Wall Coatings: A coating material used on the exterior walls of buildings. It is used to smooth, achieve a smooth surface, and protect against external factors.
• Interior Wall Coatings: Used for covering and correcting walls in indoor spaces. It ensures that the walls have a smooth surface and prepares them for subsequent coating processes.
• Ceiling Coatings: Used for correcting ceilings and achieving a smooth surface. It improves the aesthetic appearance of the ceiling and prepares it for other ceiling coating processes.
• Plaster Repair: Used for repairing damaged or cracked plasters. It can also be used to correct minor imperfections in walls or ceilings.

It is important that the surface is pre-prepared for the proper application of cement-based satin putty. Surface preparation ensures better adhesion of the putty to the surface and achieves a smoother appearance.
• Dust, dirt, oil, grease, and other residues on the surface are cleaned with a brush or broom.
• Loose parts on the surface are scraped off and cleaned.
• If present, mold and algae on the surface are cleaned with mold and algae cleaners.
• Cracks and holes on the surface are filled with suitable repair mortar.
• Sharp corners and edges on the surface are rounded off.

Add appropriate amount of water (8,5-9,5 lt water/ 25 kg bag) into the mixing bowl. Add powder material and mix with a low speed hand mixer. Rest for 5 minutes and mix until the mortar reaches homogenous consistency. The prepared mortar is applied with a steel trowel. Application thickness is 2-3 mm. For thicker applications, it is applied in two layers when the first layer shrinks sufficiently.

• No foreign materials (lime, cement, plaster, etc.) should be added to the prepared mortar.
• Mortar that has passed its usage time should not be remixed with water or dry mortar and reused.
• Full hardening process must be completed, as the material may not reach maximum durability before it has fully hardened.
• All tools used after application should be washed with water before they dry.
• It is important to immediately clean hands and skin that have come into contact with the material.
• Application should be done at temperatures between +5 °C and +35 °C.
• Should be protected against rapid drying in windy conditions.
• Should not be applied to frozen surfaces.
• Do not apply directly under sunlight.
• Do not deviate from the specified application area and instructions.
• Adequate ventilation of the workspace is required during application in enclosed spaces to avoid inhaling chemical vapors.
• Use gloves, protective glasses, and a mask to protect from material dust and chemicals.
• Do not inhale directly. If contact with eyes occurs, wash them thoroughly with plenty of water and seek medical advice if necessary.