Roofs: Can be used on all types of roofs, including flat roofs, sloped roofs, and metal roofs. Its UV resistance provides long-term protection against damage caused by sunlight.
Terraces and Balconies: Can also be used to protect terraces and balconies from water damage. By creating a waterproof barrier, it prevents water from seeping into underlying structures.
Foundations: Can be used to protect foundations from water. By preventing water from penetrating the foundation, it helps avoid basement flooding and other underground water damage.
Walls: Can also be used to protect walls from water. By forming a waterproof barrier, it prevents water from penetrating the walls and causing damage.
Pools: Can be used to protect swimming pools from water leakage. By preventing water from leaking out of the pool, it helps avoid water wastage and environmental damage.

Cleaning: The surface must be free of dust, dirt, oil, paint residues, and other contaminants. Suitable cleaners or solvents can be used for surface cleaning.
Removal of Old Coatings and Weak Layers: If there are old waterproofing materials, paint, or other coatings on the surface, they must be completely removed. The presence of weak or loose layers can hinder effective adhesion.
Correction and Filling: If there are cracks, holes, or other irregularities on the surface, they should be corrected using a suitable repair material or filler. A smooth surface ensures the uniform application of the waterproofing material.
Moisture Control: The moisture content of the surface should be checked. The material should not be applied to damp surfaces. The surface must be within specific moisture content limits before application.
Primer Application: In some cases, a primer application may be necessary to enhance adhesion.
Pre-Application Test: Once surface preparation is complete, a small test application can be performed before applying the waterproofing material. This test ensures proper adhesion and suitability of the material.

For each coat, 20 kg of powder component should be added slowly to 10 liters of liquid component and mixed with a low speed mixer for about 2-3 minutes until it reaches a homogeneous consistency. After resting the mixture for 2 minutes, it should be mixed again before application. Apply 3 coats over the entire surface with a brush or trowel. Each coat should be applied perpendicular to the previous one. Wait at least 5 hours between coats. Drinking water tanks should be disinfected with 5% sodium hypochlorite solution at least 7 days after application, washed with drinking water and then filled with water. This process should be repeated at least once a year. The specified times are valid at a surface and ambient temperature of 20 °C, the time is extended at low temperatures and shortened at high temperatures. Floors to be walked on should be covered with a topcoat such as screed ceramic etc. After application, flex ceramic adhesive should be used for ceramic coatings and flex granite adhesive should be used for granite coatings.

• Take necessary safety precautions during application, such as wearing gloves, a mask, and goggles.
• No foreign substances (lime, cement, gypsum, etc.) should be added to the prepared mortar.
• Expired mortar should not be mixed with water or dry mortar for reuse.
• Should be protected from rapid drying in windy conditions.
• Should not be applied to frozen surfaces.
• Do not apply under direct sunlight.
• Do not deviate from the specified application area and usage instructions.
• Do not inhale directly. In case of eye contact, rinse thoroughly with plenty of water and seek medical advice if necessary.
• The full curing process should be completed, as the plaster may not reach maximum durability before full curing.