Roof Waterproofing: Two-component bitumen-rubber-based waterproofing materials are commonly used for roof insulation. Roof waterproofing is essential to protect buildings from rain, snow, and other atmospheric conditions and to prevent water leaks. These materials are typically used on concrete roofs, roofing systems, or roof insulation applications.
Terrace and Balcony Waterproofing: Terraces and balconies are constantly exposed to external weather conditions and therefore require waterproofing. Two-component bitumen-rubber-based waterproofing materials are an effective choice for terrace and balcony waterproofing. When applied to terrace or balcony floors, these materials prevent water leakage and enhance structural durability.
Basement Waterproofing: Basement floors and walls require waterproofing due to exposure to underground water pressure and moisture. Two-component bitumen-rubber-based waterproofing materials are applied to basement floors and wall surfaces to prevent water leaks, providing interior protection and ensuring structural durability.
Bathroom and Kitchen Waterproofing: Bitumen-rubber-based waterproofing materials are used in bathrooms and kitchens to prevent water from penetrating the structure. This material can be applied for under-tile waterproofing, under-ceramic waterproofing, and wall waterproofing applications.

• Cleaning: The surface to be treated must be clean and free of dust. Dust, dirt, oil, paint, and other contaminants can prevent proper adhesion of the material. The surface should be cleaned by sweeping, brushing, or vacuuming.
• Removal of Old Coatings and Weak Layers: If there are old waterproofing materials, paint, or other coatings on the surface, they must be completely removed. The presence of weak or loose layers can hinder effective adhesion.
• Correction and Filling: If there are cracks, holes, or other irregularities on the surface, they should be corrected using a suitable repair material or filler. A smooth surface ensures uniform application of the waterproofing material.
• Moisture Control: The moisture content of the surface should be checked. Waterproofing materials should not be applied to damp surfaces. The surface must be within specific moisture content limits before application.
• Surface Water Absorption: If the application surface is concrete, it is important to check its water content. The concrete should be sufficiently dry; otherwise, the adhesion performance of the waterproofing material may be negatively affected.
• Primer Application (Optional): In some cases, a primer may be applied to the surface. The primer helps improve adhesion, seal rough surfaces, and control the surface’s water absorption capacity.
• Pre-Application Test: After surface preparation is complete, a small test application can be performed before applying the waterproofing material. This test ensures proper adhesion and suitability of the material.

Before applying to the surfaces to be insulated, surface smoothness, surface dryness, cleanliness and a sufficient slope screed (min. 5%) should be checked. Gaps and pits on the surface should be filled with repair mortar. After these conditions are met, the sliding based waterproofing material is applied to the surface with a brush or gun and waited until it is completely dry. It should be applied cold. The second coat should be applied 90° perpendicular to the first coat. If necessary, it can also be thinned with 20% water. Dries in approximately 4-5 hours depending on weather conditions. In two-coat applications, the second coat should not be applied until the first coat is completely dry.

• It is recommended to wear flat rubber-soled shoes during application.
• The temperature of the application surface should be between 5°C and 35°C. At lower temperatures, the drying time of the material may be extended. At higher temperatures, the drying time may shorten, potentially reducing the material’s performance.
• After application is completed, the material should be allowed to dry for at least 24 hours. During this period, the material should not come into contact with water.