On Walls: Can be used for tiling ceramics or tiles on bathroom, kitchen, and other wall surfaces.
On Floors: Can be used for tiling ceramics or tiles on floors in bathrooms, kitchens, corridors, hotel lobbies, and similar areas.
Exterior Cladding: Can be used for ceramic or tile cladding on building exteriors.
Stair Cladding: Can be used for tiling ceramics or tiles on interior or exterior stairs.
Flooring: Can be used for tiling ceramics or tiles in commercial spaces like offices, stores, and restaurants.

Cleaning: The surface to be applied should first be cleaned. All dirt, grease, dust, and other foreign substances should be removed. Suitable cleaning materials and water can be used for this process.
Smoothness Check: The surface should be checked for smoothness. If there are cracks, holes, or other defects, they should be corrected beforehand. Corrective filler materials may be used if necessary.
Use of Primer for Absorbent Surfaces: If the surface to be applied is absorbent, the use of primer may be necessary. The primer reduces the surface’s absorbency, allowing the adhesive to spread evenly and improving its bonding strength.
Plumbing and Electrical Installations Check: If there are plumbing or electrical installations beneath the application area, they should be checked, and protective measures should be taken if necessary.
Check Surface Moisture Content: The moisture content of the surface should be checked. A surface that is too wet or too dry may hinder the effective application of the adhesive. If necessary, moisture levels should be checked using moisture measurement devices.
Pre-Wetting the Surface Before Adhesive Application: Particularly on absorbent surfaces, the surface may need to be lightly wetted before applying the adhesive. This ensures that the adhesive spreads evenly and enhances its bonding strength.

• Add approximately 6.00 / 6.50 liters of water to 25 kg of powder and mix thoroughly with a low-speed mixer until no lumps remain. (The adhesive mortar used for outdoor ceramic installations should contain less liquid than the one used for indoor applications. This ensures that the mortar has greater flexibility.)
• After the mortar has matured for approximately 5 minutes, it should be mixed for another 1-2 minutes before application.
• The mortar should be applied to the surface and the thickness should be adjusted using a notched steel trowel. The size of the notches on the trowel should be determined based on the size of the ceramic tiles to be installed and the smoothness of the surface to be applied.
• The adhesive should be spread onto the surface with a trowel. The adhesive should be spread evenly across the surface. The thickness of the adhesive will vary depending on the size of the tiles. For small-sized tiles, 3-5 mm of adhesive should be applied, and for large-sized tiles, 5-10 mm thickness should be applied.
• The tiles should be placed on the adhesive. The tiles should be carefully placed onto the adhesive. Once the tiles are properly positioned, they should be lightly tapped to secure them in place. For good adhesion, force should be applied with a rubber mallet to expel air.
• The tiles should be moistened with water for 24 hours. This process ensures that the tiles and adhesive fully cure.

• It is recommended that the application be carried out at temperatures between +5 °C and +35 °C.
• The surface should be protected from rapid drying in windy conditions.
• It should not be applied to frozen surfaces.
• It should not be applied under direct sunlight.
• No foreign materials should be added to the prepared mortar.
• Mortar that has exceeded its usage time should not be mixed with water or dry mortar and reused.
• The full curing process should be completed, as the adhesive may not reach maximum durability without full curing.
• All tools used after application should be washed with water before they dry.
• Wear gloves, protective goggles, and a mask to protect against adhesive dust and chemicals.
• The work area should be well-ventilated to prevent inhalation of chemical fumes released during adhesive application in enclosed spaces.
• It is important to clean hands and skin immediately after contact with the adhesive.