• Used for vertical, upright, and overhead applications on interior and exterior facades of all types of buildings.
• Used as the final coating material in thermal insulation systems.
• Can be applied on all types of mineral surfaces.
• Applied as a coating and protective layer over cement-based plasters.

• Cleaning: The surface should be free of dust, dirt, oil, paint residues, and other contaminants.
• Repair and Correction: Any cracks, holes, or damage should be repaired using a suitable surface filler or plaster.
• Surface Smoothing: Irregularities such as bumps and protrusions should be removed to ensure a smooth surface for application.
• Surface Primer: Applying a primer can enhance the bond between the surface and the plaster.
• Water Absorption & Adhesion Test: The surface should be tested for water permeability and adhesion before plastering.
• Leveling and Smoothing: Sloped or uneven surfaces should be corrected before application.
• Moisture Content: Surface moisture should be checked and kept within suitable limits.
• Expansion Joints: Expansion joints should be considered on large areas or between different materials to prevent thermal stress.

Add appropriate amount of water (6-6.5 liters of water/25 kg. powder) into the mixing bowl. Add the powder material and mix with a low speed hand mixer. Rest for 5 minutes and mix until the mortar reaches homogenous consistency. The prepared mortar is applied to the surface with a steel trowel in equal thickness. The application thickness should be adjusted by considering the coarsest grain size in the material. The surface is patterned with circular movements with a plastic or polyurethane trowel. On large surfaces, care should be taken to use the material without a break.

• No foreign materials (lime, cement, gypsum, etc.) should be added to the prepared mortar.
• Expired mortar should not be reused by mixing with water or dry mortar.
• It is recommended to carry out the application at a temperature between +5°C and +35°C.
• It should be protected from rapid drying in windy conditions.
• Should not be applied to frozen surfaces.
• Do not apply under direct sunlight.
• Do not exceed the specified application area and instructions for use.
• Do not inhale directly. In case of eye contact, rinse with plenty of water and consult a doctor if necessary.
• The full curing process should be completed, as the adhesive may not reach maximum strength before full curing.