Cleaning: It is important to clean the surface, removing dust, oil, and other contaminants.
Oil and Dirt Removal: If there are oil, grease, wax, or similar substances on the surface, clean them using an appropriate cleaner or detergent.
Removal of Old Grout: If there is old grout and it is cracked, loose, or deteriorated, it may need to be removed.
Smoothing the Surface: The surface should be smooth and even. If there are cracks, holes, or other irregularities, fill and smooth them using a suitable material.
Moisture Control: Since grout material is mixed with water, the moisture content of the surface should be checked before application. If the surface is too moist, the grout may not adhere properly.

Mortar Preparation: 20 kg of grout should be slowly poured into 7.0-7.5 liters of water and mixed until a homogeneous mixture is obtained. The mixing should be done with a low-speed mixer. No additives other than those specified in the application instructions should be added. Adding more or less water than specified may cause cracking, dusting, and color defects. The prepared mixture should be left to rest for 5-10 minutes to mature. Before starting the application, mix again for 1-2 minutes.
Application: Apply the prepared grout material to the joints using a spatula or a special grout application tool. Ensure that the material is evenly distributed when filling the joints. Avoid applying excessive grout, as it may be difficult to clean after drying.
Smoothing and Cleaning: After applying the grout, wipe off excess material using a sponge or a clean cloth. Clean any material that gets onto the surface. If you clean the grout residue immediately, it will be easier than after it has dried.
Waiting for Drying Time: Allow the grout material to dry completely.
Final Checks and Second Coat Application if Necessary: After drying, check the surface of the grout. If necessary, you can apply a second coat.

• No foreign substances (lime, cement, gypsum, etc.) should be added to the prepared mortar.
• Expired mortar should not be mixed with water or dry mortar and reused.
• It is recommended to apply within a temperature range of +5°C to +35°C.
• Do not apply on frozen surfaces.
• Do not apply under direct sunlight.
• Do not exceed the specified application area and usage instructions.
• Do not inhale directly. In case of contact with eyes, rinse thoroughly with plenty of water and consult a doctor if necessary.
• The full curing process must be completed, as grout may not achieve maximum durability until fully cured.