• Can be used on interior and exterior surfaces, both horizontal and vertical.
• For blocking and stopping active water leaks before waterproofing.
• For repairing defects on concrete surfaces.
• For filling tie-rod holes inside formworks.
• For chamfering concrete edges and corners and repairing cold joints.
• Used for anchoring non-load bearing elements.

• The powder is gradually added to a clean container and mixed with water.
• Mixing continues until a homogeneous consistency is achieved, ensuring no lumps are formed.
• The prepared mortar should be used immediately without delay. It is applied to the area of water leakage by hand or with a trowel.
• The mortar should be applied in a way that completely covers the leakage and should be at least 2 cm thick.
• Constant pressure should be applied for at least 2 minutes until the material hardens.
• For holes that cannot be sealed in a single application, the above process should be repeated from the edges toward the center.
• After the application is complete, the surface should be cleaned by wiping it with a damp cloth.
• The material should be allowed to fully cure for 24 hours.
• During the curing period, contact with water should be avoided.

• The full curing process should be completed, as the material may not reach maximum durability before full curing. The curing time of the mortar will vary depending on the product and ambient temperature.
• No foreign substances (lime, cement, gypsum, etc.) should be added to the prepared mortar.
• Expired mortar should not be mixed with water or dry mortar for reuse.
• Should be protected from rapid drying in windy conditions.
• Should not be applied to frozen surfaces.
• Do not apply under direct sunlight.
• Do not deviate from the specified application area and usage instructions.
• Take necessary safety precautions during application, such as wearing gloves, a mask, and goggles.
• Do not inhale directly. In case of eye contact, rinse thoroughly with plenty of water and seek medical advice if necessary.